Yes, several of them in fact. Note that in some cases you need to
hardcode the speed of the NIC's, - I had problems with one box not
properly autonegotiating which caused major issues.
Add a line after "alias eth0..." in /etc/modules.conf:
options bcm5700 line_speed=xx full_duplex=yy
Replace xx with the speed (10,100,1000)
Replace yy with 1 for full duplex or 0 for half duplex
For more than 1 NIC (obviously there will be at least 2), add the
parameters as a comma separated list
Ex: options bcm5700 line_speed=100,10 full_duplex=1,0 will set eth0 to
100 Mb/FDX, eth1 to 10 Mbit/HDX, assuming eth0 and eth1 are the Broadcom
NIC's
Doug
-----Original Message-----
From: Siddhartha Jain(IT) [mailto:SiddharthaJ AT BANKMUSCAT DOT COM]
Sent: Tuesday, May 27, 2003 1:47 AM
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: [FW-1] Secureplatform on HP DL360 with Broadcom NIC
Hi,
Has anyone got Secureplatform (any version) working on HP/Compaq DL 360
G3 with Broadcom 5700 Gigabit NICs?
TIA,
Siddhartha
"This email message is intended for the named recipient only. It may be
privileged and/or confidential. If you are not the intended named
recipient of this email then you should not copy it or use it for any
purpose, nor disclose its contents to any other person which is strictly
prohibited and unlawful"
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
