Hi,
I need a virtual interface on my Secureplatform NG FP3. How is the best
way to
apply this?
If you connect with the webui you can only edit the interface and add
VLAN's.
I have added the interface with ifconfig as eth2:1 but when i reboot the
interface dissapear.
I think i have found the file that sets the ip-adresses,
/opt/CPfw1-50-03/state/local/FW1/local.set
and under /etc/sysconfig/network-scripts the interfaces are set.
What is the correct way to add a virtual interface in Secureplatform?
Kind Regards
Petra
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
