At 22:12 24.07.2003 +0200, you wrote:
>
> CPMP-MPU-1-NG Multi-CPU Support for 1 Enforcement Point
>
So that sounds a little bit...unbeleavable. As I understood, you don' t have
to buy CPMP-MPU-1-NG Multi-CPU Support but without it only one CPU is used
by fw-1.
Let's discuss the following scenario:
Once I bought a E220 with 2x Ultrasparc II. As firewall software CP 4.1 was
installed. With 4.1 you could use multi processors without any additional
no, 4.1 does not support multi-CPU.
use an eval-license and check how much faster your fw is with
multi-CPU-support enabeled and then find your decision.
cheers
reinhard
--
Reinhard Stich, ASSIST R.Stich AT internet-security DOT at
Internet Security AG, 1190 Wien, Nussdorfer Laende 29-33
Tel: +43 1 370 94 40 RS784-RIPE Fax: +43 1 370 94 40-10
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
