Rob,
This was a new installation. Cleaned IPSO3.6FCS6 upgrade to IPSO3.7 and then
add a fresh install of NG AI. I have checked the NICs, IP addresses (Interface
and virtual), subnet masks and routing.
Thanks
Dave
-----Original Message-----
Was this an upgrade or a new install. There was a post back on 7/17/2003 with
a situation with NG-AI and spoofing going beserk. In that instance it was an
upgrade and for some reason when checkpoint upgraded itself, it swapped the
nics in the topology table and that was screwing everything up. I would do a
get on the topology table first to make sure that your nics are in the right
spot with the right ip addresses before you look further into this.
Rob
** Below is the past of the email about the spoofing issue from 7/17 **
Resolved... My system now has the spoofing working OK, and it's not
complaining about excessive hosts.
I did the interface "find" click. It actually flipped the 2 NIC entries over
(kept the same name, same IP and all) but just reordered them on the FW
gateway's NIC list....
All is well. Evidently, it's picky about how it finds the NIC cards on the
PCI buss, even though the Names & IP's match, it has to something else
particular to Checkpoint's interpretation.
Thanks for the tips & help, guys.
Vic
-snip-
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
