If you are running secureplatform, you just run 'backup all tftp <ip
address>' from the Cpshell. Not sure if this applies to ipso/win2k though.
Ian
-----Original Message-----
From: Michael Schwartzkopff [mailto:ccse_fw1 AT MULTINET DOT DE]
Sent: 24 November 2003 10:29
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: [FW-1] Backup of a Module
Hi,
is it possible to make a backup of the configuration of a FW-1 module?
For test purposes I want to setup a identical system with the setup of the
active gateway copied to the new system. The SIC should also be reproduced.
If possible, how?
The separate management system works already (with upgrade to NG_AI).
Thanks.
Michael Schwartzkopff
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
