Hi,
write "cpconfig" in the command line on your IP350 and you get a menu.
One of the menu-points is for the input of a SIC password.
Use the same password on your management server.
Then, I hope, it will run...... Good luck!
Brett, Gary (19.2.2004 14:05):
##Ok, bit of a problem, All of a sudden out of the blue i tried to push a
##policy to my nokia IP350 cluster, and i get the following errors
##
##Installation Failed on Advanced security and desktop security - Reason
##-Connection Failed - SIC failure - policy installation failed
##
##
##
##I then went to the firewall module to test the SIC status and this is the
##message i get back..
##
##
##
##
##SIC Status for tagus: Not Communicating
##
##SIC General Failure [error no. 148]
##
##** Contact Check Point Support **
##
##
##
##
##
##Just for info, I can ping between the management box and both enforcement
##modules with no probs so they can reach each other networking wise
##
##any help would be greatly apprecialed
##This electronic message contains information from Halifax Cetelem Credit Ltd
##which may be privileged or confidential. The information is intended to be
##for the use of the individual(s) or entity named above. If you are not the
##intended recipient be aware that any disclosure, copying, distribution or
##use of the contents of this information is prohibited. If you have received
##this electronic message in error, please notify us by telephone or email (to
##the numbers or address above) immediately.
##
##=================================================
##To set vacation, Out-Of-Office, or away messages,
##send an email to LISTSERV AT amadeus.us.checkpoint DOT com
##in the BODY of the email add:
##set fw-1-mailinglist nomail
##=================================================
##To unsubscribe from this mailing list,
##please see the instructions at
##http://www.checkpoint.com/services/mailing.html
##=================================================
##If you have any questions on how to change your
##subscription options, email
##fw-1-owner AT ts.checkpoint DOT com
##=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
