Hi All,
Could somebody help me? I have a FW module with 4 interfaces dispatched
like this :
- eth0 connected to the LAN via a switch
- eth1 connected to the VPN via a Cisco VPN Router
- eth2 connected to the DMZ via a switch
- eth3 connected to Internet via a VSAT Router (RG2000)
Despite putting a specific rule, just after the Stealth one, which
specifies that all traffic from ANY to DMZ_NET must be allowed, my DMZ
servers can't be reach from the Internet. But from the LAN everything is
ok.
Is it any specific configuration to do on the FW module (installed on
SPLAT)?
Thanks a lot
Raz
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
