1. Yes u can do it while running, no re-install needed
2. Whell since r54 (AI) u cannot use "3rd party configuration" config if state
sync interface is not defined so yes u need it.
3. State sync interface is defined on the cluster object and not cpconfig.
bye!
/Omar
Från: Sascha Picchiantano
Skickat: to 2004-04-29 13:40
Till: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Ämne: [FW-1] VRRP setup question
Hi there,
we are now considering a failover solution using Nokia VRRPmc. I have most
of the info I need, but a couple of questions remain:
3.) I assume I can setup VRRP on a running system, or do I need to reinstall
CP?
2.) Is the state-sync interface a requirement or does it work without
state-sync?
3.) How do I enable a state-sync interface? I don't see anything in
cpconfig.
Thanks,
Sascha
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
