Hi all,
What u should do is upgrade the firewall to the latest Hotfix and
i.e. R55 Hotfix 4 and then start working,
Usually the HFA's (Hotfix Accumulators) solve most of the known and
reported problems so u'd probably be fine then.
It would probably all of solve your cvp problems, if not Check Point
support will be able to assist further.
_____
This message may contain confidential and/or proprietary information, and is
intended only for the person / entity to whom it was originally addressed.
The content of this message may contain private views and opinions which do
not constitute a formal disclosure or commitment unless specifically stated.
_____
Previous or Forwarded or Original Emails are located below this line
_____
-----Original Message-----
From: Mailing list for discussion of Firewall-1
[mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of Alb
Sent: Wednesday, May 26, 2004 11:52 AM
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: Re: [FW-1] Keeping virus/worm with CP
Hi,
I use TrendMicro CVP in a ClusterXL, installed on both nodes...
I've just updated VirusWall with the new scan engine.. Hope this will
end with the need of restarting VirusWall sometimes, because it stop
working , I don't know why.
regards
Alb
Robert Plaenk wrote:
>Check Point has historically had problems with CVP...or at least I did.
>CVP would always break. Actually, it's not the CVP protocol that is
>breaking, but rather Check Point Security Server that would "break". In
>all cases, it just required a reboot of the firewall. But this can be a
>huge problem in some environments.
>-----Original Message-----
>From: Mailing list for discussion of Firewall-1
>[mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of daniel
>owen
>Sent: Tuesday, May 25, 2004 1:01 PM
>To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
>Subject: Re: [FW-1] Keeping virus/worm with CP
>
>I had approximately the same results with SMTP and Interscan Virus wall
>under CVP. I would periodically just quite receiving mail and need to
>restart the FW server. In retrospect I think this may have been an issue
>with kernel memory depletion but I'm not really sure.
>
>Unfortunately Trend's support is pretty much useless on the subject of
>CVP. The answer every time was have you tried upgrading to a newer build
>and if I had they would tell me it should work. No amount of additional
>questioning would get another answer. Checkpoint's support was more
>helpful but I gave up before I ever got a solution. I am planning on
>rebuilding my Trend server in CVP mode again in about a month to see if
>my move from NG to NG AI (R55) or moving to the newest version of
>Interscan will improve this. I really liked CVP mode when it worked.
>
>Overall I like the Trend software but the support leaves me with the
>impression that they have only one goal and that is to get off of the
>phone and on to the next customer.
>
>
>
>-----Original Message-----
>From: Mailing list for discussion of Firewall-1
>[mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM]On
>Behalf Of RoNNY
>Nussbaum
>Sent: Tuesday, May 25, 2004 7:06 AM
>To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
>Subject: Re: [FW-1] Keeping virus/worm with CP
>
>
>Hello.
>Working with Interscan Viruswall in CVP mode gave us a lot of problems,
>mainly with mail stuck in a queue.
>The HTTP and FTP scanning are very problematic when using CVP.
>
>I really recommend not using CVP, and working with Viruswall (or
>InterScan Messaging Security Suite) in stand-alone mode. It works
>perfectly with no issues at all.
>
>-RoNNY
>
>
>
>
>
>
>
>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
---
<BR>Incoming mail is certified Virus Free. _____ Previous or
Forwarded or Original Emails are below: _____ <BR>
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.690 / Virus Database: 451 - Release Date: 05/22/2004
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
