Thanks for the suggestion, and Yes, I have even tried to rebuild the list
using cpconf but that didn't work either.
I read somewhere that synchronizing the date helps, but that doesn't explain
how I can use my laptop to connect with an IP assigned during the
installation of the FW, but the same laptop on a new IP is blocked
regardless of the cpconf settings.
At the moment the cpconfig gui-client list is being completely ignored?!?
rebooting does not help, reinstalling the policy does not help.
> From: Chris Hoff <choff AT CORNERSTONESECURITY DOT COM>
> Reply-To: Mailing list for discussion of Firewall-1
> <FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM>
> Date: Wed, 21 Jul 2004 16:57:24 -0500
> To: <FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM>
> Subject: Re: [FW-1] SmartCenter Blocking on R55?
>
> Have you tried using cpconfig at the CLI? I think I remember hearing
> about an issue like this in an earlier version of SPLAT, and using
> cpconfig took care of the problem.
>
> Regards,
>
> Chris
>
> -----Original Message-----
> From: Mailing list for discussion of Firewall-1
> [mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of Darren
> Martz
> Sent: Wednesday, July 21, 2004 2:10 PM
> To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
> Subject: [FW-1] SmartCenter Blocking on R55?
>
> [NG AI R55 HFA 04 on SecurePlatform]
>
> On a new installation of R55, the smart-client addresses I configured
> during installation are the ONLY addresses the server will allow. I have
> changed the gui addresses in the WebUI, but the settings are completely
> ignored.
>
> It just does not make any sense.
>
> I checked the /etc/fw/conf/gui_client.def file and it still states the
> original settings, but /etc/fw/conf/gui-client shows the webui settings.
>
> Has anyone run into this problem before? How can I fix it?
>
> Also, I have installed the firewall a few times this week and in all
> instances this situation has occurred - 100% reproducible on a new
> install.
>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
