I am having a discussion at work about how SmartDefense works with flows.
>From what I know of how CheckPoint handles the connection it checks source
>destination and what it is doing and then allows the connection to flow
>through at a lower level in the OSI. It places the basic information of the
>connection in a state table and matches it up and allows the traffic to flow
>through.
So how is Smartdefense going to check for signatures if it is only checking the
start of the communication?
To get the full ability of Smartdefense should flows be turned off?
If flows is turned off how is this going to affect resources?
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
