I have ISP Redundancy configured on my FW, I use one DSL line with Cisco
Router and another one with PPPOE DSL Modem. I use Load Sharing
configuration.
The status of my both connections is ok, but I see that all the traffics
goes via my first connection and no traffic goes to my second modem.
When I power off my router on the first line all the traffic goes to the
second line, but when I power on the router again all the traffic goes
there and my second line "dies" again.
Also if I switch my firewall to Primary/Backup configuration and setup
my second line as primary it works fine.
Any ideas how can I make this two lines work together ?
Thank you.
<http://100273.sigclick.mailinfo.com/sigclick/03050201/07024F04/0B490022
523013.jpg>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
