Hi ALL,
We have installed Checkpoint NG FP2 and configured it in office mode for remote
users to access internal resources through the checkpoint gateway using Ip Sec.
For this i used the guide prepared by checkpoint titled "How to configure
SecureClient, Office Mode, Certificates, and Remote Access Communities in NG
FP-3". I was able to follow for the most part. I had one question in the
section where it is mentioned "Configuring your VPN-1/Firewall-1 Object" in
Figure 3.1. The network object
Name IP comment
Behind NAT
Net_172.16.1.0 172.16.1.0 Yes
When "Yes" is shown under Behind NAT column what does that mean. How do you
configure NAT properly here so that the example network given in the guide will
work properly. Can somebody help me with what natting rules should be
configured.
Any help would be greatly appreciated.
-thanks,
Sam
---------------------------------
Do you Yahoo!?
Win 1 of 4,000 free domain names from Yahoo! Enter now.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
