Hi Aiggno,
did you adjusted SQ_MAX_SIZE to some value? (We're running a value of 500 on an
V440.)
Have a look at
http://sunsolve.sun.com/search/document.do?assetkey=1-9-71160-1&searchclause=out%20of%20stream%20resource
Regards
Torsten
> -----Ursprüngliche Nachricht-----
> Von: Mailing list for discussion of Firewall-1
> [mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] Im
> Auftrag von Aiggno
> Gesendet: Montag, 22. November 2004 14:49
> An: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
> Betreff: [FW-1] Bge interfaces on Sun V240
>
>
> Hi all,
>
> I install Checkpoint R55W to my Sun V240 server. It seems that the
> Checkpoint do not accept the bge interfaces on the V240. I
> did add the bge
> accept to the fw.boot/ifdev already. Below is the log:
>
> SunOS Release 5.8 Version Generic_117350-02 64-bit Copyright
> 1983-2003 Sun
> Microsystems, Inc. All rights reserved.
> Hardware watchdog enabled
> FireWall-1 boot security configuration:
> FW-1: Disabling IP forwarding
...
> FW-1: Autopushing over ce
> FW-1: Autopushing over bge
> ap: ioctl failed: Out of stream resources
> FW-1: bge autopush failed: resetting ...
> Usage:
> ap -a drv minor last-minor mod [mod ...]
>
> add: last-minor = 0 means one and not range
> minor = -1 means all
>
>
> ap -r drv minor
>
> remove: minor should be in range (0 for all)
>
>
> ap -g drv minor [ place mod [mod ...]]
>
> get: minor should be in range (0 for all)
> prints arguments for add command
> place specifies where to insert mod
>
>
> See also autopush(1M)
>
>
> Other options:
>
> ap -e drv mod
> query: check if mod is already autopushed over drv
>
> ap -g: ioctl failed (0): No such device
...
> configuring IPv4 interfaces:FW-1: i/f bge0 (bge0) is not
> found in table
> (SIOCSLIFNETMASK 8078697e)
> Warning: this interface is not monitored by FireWall-1
> FW-1 IP: FW-1 has a problem registering an interface configuration
> command (8078697e) - blocked.
> NOTICE: bge0: link down
>
> Do anyone see that error ? Please help.
> Best regards,
> Aiggno
>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
