Did you delete the old site in Securemote and recreate it for the new
gateway?
Ray
From: Dennis Pham <dennis.pham AT SUPERFUND DOT COM>
Reply-To: Mailing list for discussion of Firewall-1
<FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM>
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: [FW-1] unable to VPN after removing old internet line
Date: Tue, 21 Dec 2004 18:46:46 -0500
Hello everyone,
I have CheckPoint NG with AI R55 and it used to be on a DSL line with one
public IP address. I was able to VPN into the internal network and
everything worked fine. My T1 finally arrived and I switched everything
over
to the T1 IP address and my site to site VPN is working fine but I can't
seem to do a client to site VPN. I will get an error that it is unable to
communicate with the gateway everytime I try to VPN into my network from
home with my laptop. I have checked the policy and the IP configuration and
the routes and everything seems fine. So what I did to test the VPN was to
connect the old DSL line back into the firewall along with the T1 and when
I
got home I was able to connect via VPN. But when I check the SecurClient I
see that it is connected to the IP address from the T1. Is it somehow
trying
to authenicate using the old DSL IP address? Is there a file or cache
somewhere that is holding the old DSL IP address? Or is there another
solution? Any help would be appreciated.
thanks in advanced,
Dennis
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
