Hi,
I have CheckPoint R55 on SPLAT and I have some dificulties removing an
interface from it.
Original setup was like this:
eth0 -> 192.168.x.y (internal lan)
eth1 -> x.y.z.q (to the internet) (provider A)
eth2 -> a.b.c.d (to the internet) (provider B)
After switching providers, the setup is like this:
eth0 -> 192.168.x.y (internal lan)
eth1 -> x.y.z.q (to the internet) (now disabled)
eth2 -> a.b.c.d (to the internet)
eth2.200 -> external vlan
eth.300 -> internal vlan
The problem now is that if I run sysconfig, and choose to remove network
connections, only two interfaces are displayed: eth2.200 and eth2.300
How can I remove the eth2 and eth1 interface from the network connections ?
thank you,
sin
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
