Firewall-1

Re: [FW-1] VPN-1 Edge X Setup

Subject: Re: [FW-1] VPN-1 Edge X Setup
From: "Stephen W. Stewart" <stewart.sw AT TKDA DOT COM>
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Date: Fri, 18 Feb 2005 09:09:33 -0600
The DNS is set on the Edge, both my network DNS server and also the DNS
server of the ISP.



Stephen W. Stewart
-----Original Message-----
From: Mailing list for discussion of Firewall-1
[mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of Russell
Aspinwall
Sent: Friday, February 18, 2005 1:21 AM
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: Re: [FW-1] VPN-1 Edge X Setup

Hi,

Is there a chance of having a Dynamci DNS server incorporated with the
DHCP server on the Edge units, so that on the LAN interface you can set
the DNS name when you enable DHCP. Or is it already there?


Ray wrote:
> Check out 5.0.50. It fixed a bunch of VPN problems in 5.0.43 including

> a memory leak that made me have to reboot mine every few days.
>
> Ray
>
>> From: Russell Aspinwall <russell.aspinwall AT FLOMERICS.CO DOT UK>
>> Reply-To: Mailing list for discussion of Firewall-1
>> <FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM>
>> To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
>> Subject: Re: [FW-1] VPN-1 Edge X Setup
>> Date: Wed, 16 Feb 2005 14:15:15 +0000
>>
>> Hi,
>>
>> I have used a variety of firmware versions on the Edge and found
>> v5.0.43x a vast improvement since v4.0.93x and many in between. Site
>> to Site VPNs offer a significantly better level of performance and
>> reliability, primarily NGAI R55 to Edge, Edge to Edge VPNs have not
>> been a problem.
>>
>> Stephen W. Stewart wrote:
>>
>>> Hi All,
>>>
>>> Trying to set up an Edge X box for a remote office in Site to Site
mode.
>>> I currently have 2 other sites that are working just fine.  The only

>>> difference with the new X is that it will have a static IP and the
>>> two that are working are using DHCP.
>>>
>>> I can create the site and then look in the reports section at the
>>> VPN Tunnels section and nothing shows up.  If I ping the internal IP

>>> of the X box a tunnel is established and the X box replies.  I
>>> cannot ping the other way into the "home" network behind the FW-1.
>>>
>>> The established tunnel shows IKE (Phase 1): 3DES/SHA1.
>>>
>>> Any ideas?
>>>
>>> Thanks
>>>
>>>
>>> Stephen W. Stewart
>>>
>>> =================================================
>>> To set vacation, Out-Of-Office, or away messages, send an email to
>>> LISTSERV AT amadeus.us.checkpoint DOT com
>>> in the BODY of the email add:
>>> set fw-1-mailinglist nomail
>>> =================================================
>>> To unsubscribe from this mailing list, please see the instructions
>>> at http://www.checkpoint.com/services/mailing.html
>>> =================================================
>>> If you have any questions on how to change your subscription
>>> options, email fw-1-owner AT ts.checkpoint DOT com
>>> =================================================
>>>
>>
>>
>> --
>> Regards
>>
>> Russell
>>
>> =================================================
>> To set vacation, Out-Of-Office, or away messages, send an email to
>> LISTSERV AT amadeus.us.checkpoint DOT com
>> in the BODY of the email add:
>> set fw-1-mailinglist nomail
>> =================================================
>> To unsubscribe from this mailing list, please see the instructions at

>> http://www.checkpoint.com/services/mailing.html
>> =================================================
>> If you have any questions on how to change your subscription options,

>> email fw-1-owner AT ts.checkpoint DOT com
>> =================================================
>
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
>


--
Regards

Russell

Email: russell dot aspinwall at flomerics dot co dot uk
Network and Systems Administrator           Flomerics Ltd
Telephone: 020-8941-8810 x3116              81 Bridge Road
Facsimile: 020-8941-8730                    Hampton Court
                                             Surrey, KT8 9HH
                                             United Kingdom

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================

<Prev in Thread] Current Thread [Next in Thread>