Hi All ,
I have purchased two Sun-iforce boxes with Secureplatform . I have also
setup the boxes with Clusterxl in Load sharing> Multicast.
I have tested it via the cphaprob cmds and fw ctl pstat.
Some questions.
1. Is there a procedure or best practice to test Load sharing,high
avalabilty and failover. I have tested by doing icmp ping to all
intrerfaces on subnet .
Eg int 1 --- Ping -response - Fw a
Int1 - ping - no response - Fw B
Vitrual Address - Ping -- response
I also did a icmp ping to the virtual address on the Fw cluster and
when I reboot the one box there is no drop in icmp responses but when I
reboot the other there
Are timeouts until it comes up. With nokia ip clustering I did not have
this problem. Any ideas ??
2. What is vpnx ?? . How can I implement it and what is its effect
on clustering ??
I need to get as close to possible with clusterxl as to Nokia's Ip
clustering - Load sharing,high avalabilty and failover.
Is there any best practice to Test Load sharing,high avalabilty and
failover ??
I also have multiple cpu's is a special license for this ?
Also with Nokia Ip clustering one could do a cluster safe reboot via
http browser page to the virtual address but if I try browse to the
virtual adresss via http on secureplat
I cant get the page .. Any advice
Thanks
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
