I run two Nokia 380's with Ipso 3.7.1 and simplified vrrp. I have multiple
vlans on them, vrrp ha
has been running fine for months.
recently I created three new vlans close to the recommendations in Nokia KB
ending up in a master
/ master situation for the three new vlans. I then did the whole stuff again:
ensured interfaces
are right defined in dashboard, deleted, rebooted, recreated etc. Nothing
changes - always when I
set up the 3 new vlans there is a master / master. Regardless to say I started
a case at Nokia,
running now but I think it'll take lightyears for them to solve (greetings to
the other thread
just going around).
Recently the situtation changed: Now I have a master / master situation for all
interfaces. Funny
thing, since nothing on the nokias has changed. Since this made horrible
problems in production I
deleted the whole virtual routers on both a recreated, one at a time, ending up
again in a master
/ master.
Since I have setup a lot of vrrp clusters I am sure I made no mistakes in this
case, but it won't
work as it should.
Anybody any ideas?
Thx and a nice weekend
___________________________________________________________
Gesendet von Yahoo! Mail - Jetzt mit 250MB Speicher kostenlos - Hier anmelden:
http://mail.yahoo.de
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
