Hi Techies,
I've recently added a route via voyager to a checkpoint 4.1 primary and
secondary Fw1 with ipso versions 3.5,
however i cannot view the entries added via command line,
i've taken off the routes and re-applied them, (applying and saving in the
process) same thing ! no entries in the routing table all , even though i can
see the routes in Voyager, something's not right here for sure,
A colleague was hinting that there's a maximum number of routes that could be
added to the routing table, i must say the routing table is quite lengthy, but
should that be a problem?
Any ideas
thanks
Ads
Send instant messages to your online friends http://uk.messenger.yahoo.com
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
