At 07:29 AM 4/27/2005, Ade Shoy wrote:
Hi Techies,
I've recently added a route via voyager to a checkpoint 4.1 primary and
secondary Fw1 with ipso versions 3.5,
however i cannot view the entries added via command line,
i've taken off the routes and re-applied them, (applying and saving in the
process) same thing ! no entries in the routing table all , even though i
can see the routes in Voyager, something's not right here for sure,
A colleague was hinting that there's a maximum number of routes that could
be added to the routing table, i must say the routing table is quite
lengthy, but should that be a problem?
Any ideas
I've seen this before when I was configuring an new IP740 that WASN'T
attached to the network. The
netstat -rn wouldn't see them but Voyager did. When placed on the network
it would be recognized by netstat. I do have one Nokia with 160 static
routes and if you have less than that, it shouldn't be a routing issue but
my version of ipso is 3.7.1.
Hope this helps....
-- Joe
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
