Hi All - I don't remember if I ever posted this question or not.
We have two Nokia IP500's running software release: 3.6FCS6 and ver:1061-2003
I don't know much about these boxes (a consultant install) - just enough to be
dangerous.
They are configured in VRRP failover.
The issue/symptom is this -
We use HTTP to management the boxes.
Access to the Primary is no problem. The screens come up in a matter of
seconds.
The problem is the Secondary - it takes many seconds sometimes minutes to get
bring up a screen.
Any ideas on this - aside, of course, from the normal cable/port duplex and
speed settings.
Thank you
Mike Robare
Network Admin.
Fuji Photo Film
914-789-8628
For PC HelpDesk: x:7999
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
