Hi All,
I understand there r 2 modes in CP for redundancy (Correct me if i'm wrong).
There is HA where 1 module would act as a backup to the other & load sharing
where modules would be in active/active state ie. almost equal session
distribution. In any of the modes would there be a session failover also, if
the primary module fails or is down?
Thanks in advance.....
Regards,
BG
Confidentiality Notice
The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
Mailadmin AT wipro DOT com immediately
and destroy all copies of this message and any attachments.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
