Both of these methods use the same process for synchronizing state. So
it doesn't matter if you use HA or active/active both will have
session fail over.
On 5/30/05, Bhavin Gandhi <bhavin.gandhi AT wipro DOT com> wrote:
> Hi,
>
> Which of the methods take care of session failover?
>
> Regds,
> BG
>
> -----Original Message-----
> From: Mailing list for discussion of Firewall-1
> [mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM]On Behalf Of
> Reinhard
> Stich
> Sent: Monday, May 30, 2005 10:37 AM
> To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
> Subject: Re: [FW-1] Firewall session failover
>
>
> At 06:21 30.05.2005, you wrote:
> >Hi All,
> >
> >I understand there r 2 modes in CP for redundancy (Correct me if i'm
> >wrong). There is HA where 1 module would act as a backup to the other &
> >load sharing where modules would be in active/active state ie. almost
> >equal session distribution. In any of the modes would there be a session
> >failover also, if the primary module fails or is down?
>
> that's right.
>
> cheers
> reinhard
>
> >Thanks in advance.....
> >
> >Regards,
> >BG
> >
>
>
>
> Confidentiality Notice
>
> The information contained in this electronic message and any attachments to
> this message are intended
> for the exclusive use of the addressee(s) and may contain confidential or
> privileged information. If
> you are not the intended recipient, please notify the sender at Wipro or
> Mailadmin AT wipro DOT com immediately
> and destroy all copies of this message and any attachments.
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
