Hi
Got a remote site that is using SPLAT FP3 - Everything was fine until a
power cut. Box boots but no connectivity goes through it. Doing a local
policy unload on it still does not allow any pings from that box out. I
also can't ping in with the policy unloaded which i could before.
Putting another box on the line instead of this module with interface
configured as per the external interface of this module i can get out so
i think the link is fine.
Anyone have a tips to get past this? This module is in Spain and i am
not which is a pain and its getting urgent - Are there any other
commands that i can run for debug purposes? The configuration of all
interfaces and routes seems intact.
thanks
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
