Hi, all
One of our clients has site to site VPN tunnel setup for software vendor
support access. The client runs AI R55 HFA-03 with simplified mode.
The client wants to limit remote access through the VPN tunnel for
compliance. The client has secureclient setup with MS-AD authentication
done. One way I can think of is to use client or user authentication.
Normally disable the user account in MS-AD. When the vendor needs to
access, call help desk, enable the account then authenticate but
CheckPoint support told me that client auth is only supported on
traditional mode. Does anyone have any better way? Thanks a lot.
Ryan Jiang
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
