Hey!
I have one issue, I have two nokia modules with R55, the Smarcenter in
Solaris 2.8. When I run the cphaprob state I can see the two modules are
active when one should be in standby, everything works fine, the tracker
reports everything going out through module1.
The cluster is configured with VRRP. In the VRRP Monitor I can see the
interfaces of the active firewall as master and the other module as backup.
I can't understand why the output of the command is active active. Sometimes
when I did cphastop and cphastart the situation was corrected, but now It
doesn't.
Any thoughts??
Lino E. Avila
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
