I have 3 offices connected together with site to site vpn's. I'm using
SecuRemote when I'm not at the office, to connect to my main office.
When I'm connected to the main office, I can reach everything at that
location, but not at the other offices that are connected to the main
office via the site to site vpn's.
I've been told in the past, that I can't configure SecuRemote to allow
traffic to all three offices over a single SecuRemote site profile, and
that I'd have to create 3 site profiles (1 for each office).
Assuming that information is correct, I've created 3 site profiles. 2
of those work fine, but when I try to add the 3rd site, I get the
following error: "add/update site can cause overlap with current active
server. please disconnect before you add/update this site."
Questions:
1. What isn't configured correctly that makes 2 of these sites overlap?
1 site always works, and the other 2 overlap and I have to disable one
before I can complete setting the profile up.
2. Is there a way to allow traffic to the site to site vpn locations
over a single SecuRemote site profile?
Brian Hope
Network Administrator
BenefitVision, Inc.
2690 Commerce Dr. Suite 200
Harrisburg, PA 17109
Phone: (717)920-2200 ext. 104
Fax: (717)920-2690
bhope AT benefitvision DOT com
Privacy & Confidentiality of Information Notice:
This Communication may contain non-public, confidential or legally
privileged information intended for the sole use of the designated
recipient(s). If you are not the intended recipient, or have received
this communication in error, please notify the sender immediately by
reply email or by telephone at 1-800-810-2200, and delete all copies of
this communication, including attachments, without reading them or
saving them to disk. If you are the intended recipient, you must secure
the contents in accordance with all applicable state or federal
requirements related to the privacy and confidentiality of information,
including the HIPAA Privacy guidelines.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
