Re: [FW-1] how to delete a flow from connection table?

[Reinhard Stich [Permanent Link]]

hi,

you can do that on smartview-tracker -> active connections.

cheers
reinhard

At 22:45 29.10.2005, you wrote:
> Hi,
>
> Is there a way to remove a connection from the connection table ? 
> For example, I do not want to use sam.
> Thanks
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
--
Reinhard Stich  ASSIST  R.Stich AT internet-security DOT at
Internet Security AG,      1150 Wien, Johnstrasse 29
Tel: +43 1 3709440 RS784-RIPE Fax: +43 1 3709440-333 

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================