Hi all,
I'm new in the CheckPoint world. We have a Nokia IP120 Firewall with
CheckPoint NG FP3 installed on. Before this Nokia, I had never seen a
CheckPoint system. My problem is that when I try to connect with
SmartDashboard to the Firewall, it responds that I cannot connect and to
verify that server is up and running. I connected with SSH and did a "ps
aux" and "netstat -a" to see what processes were running. Searching on
the internet with google, I've found that for SmartDashboard to work, a
daemon listening on port 18190 is required (fwm, is it right?). fwm was
not running and there wasn't anything listening on that port. So I tried
to start manually fwm (typing "fwm" at the prompt) but I got only a
Segmentation Fault. Searching again on google, someone told he resolved
a similar problem by deleting all the logs and restarting the firewall
(fwstop, rm $FWDIR/log/*, fwstart). I tried, but with no success. At
this point I don't know what else do, and hope in your help!
Thanks
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
