Hi all.
I have integrated my checkpoint NG with AI R55 with Proventia IDS
appliance. Everything is working ok i.e connections are being blocked
using FW1_Sam service. Now I want to view all those ips that have been
blocked by SAM. The doc says that I should use fw tab -t
sam_blocked_ips. But when I am using this command ,it says" Cannot open
/Device/FW1.
Is there any specific path from where I can run this command . I cannot
even use fw tab -s
Zubair Jalal
Sr. C.S.E - Network & security
Wipro Ltd. | 124, Thapar House,
Janpath, New Delhi -110001.
Voice: +91-11- 23366997 ext. 274
Mobile:+91-9899004742
Email: zubair.jalal AT wipro DOT com
Web: http://www.wipro.co.in
Confidentiality Notice
The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
Mailadmin AT wipro DOT com immediately
and destroy all copies of this message and any attachments.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
