Edward Luck wrote:
> Hi folks,
>
> I have previously built SPLAT boxes running R55W and forced the
> interface duplex to 100mb/s, as with this example on a DL380G4:
>
> options e1000.4.6.11 Duplex=2,2,2,2 Speed=100,100,100,100
> options bcm5700 line_speed=100,100 full_duplex=1,1 auto_speed=0,0
>
> However, I just tried the same thing on an identically configured
> DL380 running R55 (*not* R55W), and all the interfaces disappeared
> when it rebooted! I had to remove these lines from modules.conf to
> get the interfaces back again.
>
> Has anyone seen this before? Does it even make sense? I sure don't think so.
>
If you get the modules parameters wrong, the module will not load, hence
the "disappearing" of the interfaces.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
