Hi,
I have two Checkpoint firewalls in cluster in HA
mode.The problem i am facing is ,i am unable to get
the Interface Topology information for a specific
network on cluster member but able to get on the other
memeber which is the master firewall.Due to this
problem i am unable to route the traffic through the
cluster.whether anybody has faced this kind of
problem? The physical connectivity is fine for both
the firewalls..?what are the probable reasons the
firewall may not pick up the Interface topolgy for a
particular network..?
Thanks for the help in advance...
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
