Errors related to Mass Storage during Splat installs are very obviously
stated. You get no error before the untimely death of your install.
I have experienced errors with the ramdisk not loading before (machine was
using a perfectly fine IDE drive). Resolved it with new memory. Maybe I
just got lucky, but try swapping a stick or two of mem from that machine.
Beyond that, however, you may run into issues with SATA mass storage device
during the install. But you will know that is the case when you see the
error message.
Neil Delacruz
On 1/19/06, Miguel Angel Gutierrez <miguelangel AT telvista.com DOT mx> wrote:
>
> I got a good one here...
>
> I'm supposed to change the hardware of my actual SPLAT NG(R55) box...
> the thing is, that the new box only has one SATA-HD, and a couple of USB
> ports (boot capable).
>
> No extra IDE, No floppy, No nothing...
>
> So, right now I'm booting from a USB floppy (because that's ONLY thing I
> got), trying to make the FTP install trough the box's NIC; I get the
> welcome screen, loading kernel.... loading ramdisk.... and that's it,
> right after the ramdisk loading, the whole box dies.
>
> Is it that SPLAT doesn't run under a SATA HD? Do I need to change
> something on my bootdisk? So far, I haven't been able to find any thing
> usefull under Checkpount's Knowledgebase.
>
> Regards...
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
