Hi all,
I hope someone can help me here.
I want to export a raw log to an ASCII file.
I have used this command:
fw logexport -n -m raw -i fw.log -o out.txt
However, I got the following error message.
ld.so.1: fw: fatal: relocation error: file fw: symbol __user_mode_inet6__:
referenced symbol not found
Killed
Is that the right way to export a log file to ascii by using command(I don't
want to use the SmartDash Board, because I want to write a corn job to
export the file nightly). Can someone please give me a hand here.
Thanks in advance!
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
