[FW-1] Check Point's state synchronization through both Cisco 6500 seriesswitches

[Alex S. [Permanent Link]]

Hi all,

I would like to know if anybody here had had configure or set up Check 
Point's state synchronization between two firewall separated via two 
Cisco 6500 series switches in between? I had a hard time to configure 
this. I did follow certain configuration in ClusterXL documents but it 
still doesn't work properly which resulting both side seeing each other 
down. Please help. I have no more solution about this. Thanks.
Regards,

Al

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================