Are you using vlan tagging? make sure you can test your clusterxl
without vlan tagging to check wheather this is the problem. If so, check
NGX release notes:
"When defining a Sync interface on a VLAN interface, it can only be
defined on the lowest VLAN tag on a physical interface."
regards
Alex S. wrote:
> Hi all,
>
> I would like to know if anybody here had had configure or set up Check
> Point's state synchronization between two firewall separated via two
> Cisco 6500 series switches in between? I had a hard time to configure
> this. I did follow certain configuration in ClusterXL documents but it
> still doesn't work properly which resulting both side seeing each other
> down. Please help. I have no more solution about this. Thanks.
>
> Regards,
>
> Al
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
