Hi,
No. I do not using VLAN tagging. I did a test without VLAN tagging and
it is still doesn't works. I noticed there's a specific configuration
for Cisco 6500 series for this.
Regards,
Al
Javier Hijas wrote:
Are you using vlan tagging? make sure you can test your clusterxl
without vlan tagging to check wheather this is the problem. If so, check
NGX release notes:
"When defining a Sync interface on a VLAN interface, it can only be
defined on the lowest VLAN tag on a physical interface."
regards
Alex S. wrote:
Hi all,
I would like to know if anybody here had had configure or set up Check
Point's state synchronization between two firewall separated via two
Cisco 6500 series switches in between? I had a hard time to configure
this. I did follow certain configuration in ClusterXL documents but it
still doesn't work properly which resulting both side seeing each other
down. Please help. I have no more solution about this. Thanks.
Regards,
Al
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
