Hi there,
I read about State Synchronization in ClusterXL document saying that
"There are two restrictions to the synchronization network:
First, VLANs cannot be used in the synchronization network in any
version. Second, in older versions, the interface used for the
synchronization network must be a real interface with a real IP address
(as opposed to a cluster IP or a virtual IP)." page 15.
I have two Cisco Catalyst 6500 series which is connected each other
fibre (trunk together) and our firewall are connected to it on both side
through dedicated VLAN two on location A and one in location B).
My question is does it really works? Anybody had done a state sync
across two routing switches before? If yes, can someone kindly give me a
guide about this?
Thanks very much.
Regards,
Al.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
