Firewall-1

Re: [FW-1] State Sync does not supports VLAN ?

Subject: Re: [FW-1] State Sync does not supports VLAN ?
From: fwguru <fwguru AT GMAIL DOT COM>
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Date: Wed, 19 Apr 2006 03:06:20 -0400
Are you saying that the synch interface on one firewall is on a different
network than the synch interface on the other member firewall?  And your
question is "will that work?"

Neil Delacruz


On 4/19/06, Alex S. <alexals AT kkipc DOT com> wrote:
>
> Hi there,
>
> I read about State Synchronization in ClusterXL document saying that
>
> "There are two restrictions to the synchronization network:
> First, VLANs cannot be used in the synchronization network in any
> version. Second, in older versions, the interface used for the
> synchronization network must be a real interface with a real IP address
> (as opposed to a cluster IP or a virtual IP)." page 15.
>
> I have two Cisco Catalyst 6500 series which is connected each other
> fibre (trunk together) and our firewall are connected to it on both side
> through dedicated VLAN two on location A and one in location B).
>
> My question is does it really works? Anybody had done a state sync
> across two routing switches before? If yes, can someone kindly give me a
> guide about this?
>
> Thanks very much.
>
> Regards,
>
> Al.
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
>

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================

<Prev in Thread] Current Thread [Next in Thread>