Hello,
has anyone successfully installed a NGX-HFA on a Nokia IPSO
VRRP-Cluster with full connectivity?
I tried to do a fcu for the update from R60 to R60 HFA_02 using the
following sequence of commands:
1.) Installed HFA_02 on the backup system and rebooted the system:
State-sync was "ready"
2.) On the backup system i issued a fw fcu <primary IP>
It reported a successful full-sync and the active Clusternode
stopped processing traffic (ups!).
3.) I changed the VRRP-priority so that the backup system got the
higher priority, still no traffic was processed.
4.) I installed the HFA_02 (which issues a cpstop) on the other node,
still no traffic
5.) The cluster started to work again after the reboot of the second
cluster node.
So the cluster was down for several minutes which should not happen
again.
Regards,
Achim
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
