As explained: there are several forms of clustering.
High availability: two modes: New Mode and legacy mode, i recommand the New
Mode. Load Sharing: two modes: Multicast Mode and Unicast Mode (The easiest
way, because there's one pivot who's in control of assigning the session to
the other cluser member and itself, the pivot is chosen automatically and
no changes or config on switches routers is needed to make this work).
When you choose high availability you can choose for State Synchronisation.
If you do so, if one node fails, the standby will become active and the
sessions will continue wihtout problems because of the state sync. If you
wish your VPN session to continue you will need to use the Virtual Tunnel
Interface, a new option in R60.
Regards,
Reinoud.
-----Mailing list for discussion of Firewall-1
<FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM> wrote: -----
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
From: Clive Luk <clive AT ILANET.NET DOT AU>
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
