On the Nokia Voyager VRRP config page, do you have the "Monitor Firewall State"
radio button set to "Enabled"? If not, that's the problem. When enabled, a
cpstop *should* cause a failover to the other box.
-----Original Message-----
From: Mailing list for discussion of Firewall-1 [mailto:FW-1-MAILINGLIST AT
AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of Lino Eduardo Avila Rodríguez
Sent: Tuesday, May 23, 2006 10:55
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: [FW-1] vrrp and cp
Hi all!
I have a question regarding vrrp and checkpoint. Recently I did a cpstop on one
of my nokia appliance, I assumed everything will move to the other appliance,
but it didn't, is this behavior ok? Or the machine should go down in order to
route the traffic on the other box?
I have R55 with IPSO 3.8
Best Regards,
Lino
=================================================
To set vacation, Out-Of-Office, or away messages, send an email to LISTSERV AT
amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
*************************************************************************
The information contained in this communication is confidential, is
intended only for the use of the recipient named above, and may be
legally privileged.
If the reader of this message is not the intended recipient, you are
hereby notified that any dissemination, distribution or copying of this
communication is strictly prohibited.
If you have received this communication in error, please resend this
communication to the sender and delete the original message or any copy
of it from your computer system.
Thank you.
*************************************************************************
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
