Re: [FW-1] Installing SPLAT on Dell PowerEdge 2850 (UNCLASSIFIED)

[Ramki Security [Permanent Link]]

I had done the same install on R60 HFA3 on the same hardware but without 
the additional harddisks you have.  It went through fine.  May be you 
want to put only one HDD in its default configuration and try installing 
again to see it that helps.
Ramki
CCNA, CCSE-NGAI

Dearing, Jimmy (EDS Contractor) wrote:
> Classification:  UNCLASSIFIED 
> Caveats: NONE
> Ive been attempting to install SPLAT on a Dell PowerEdge 2850 Server that
> has dual 3.8ghz processors with 2mb L2 Cache, 12gb RAM, Dual Embedded Intel
> Gigabit1 82541 Server Adapter, PERC 4e/Di controller. It has six 15,000rpm
> 146gb hard drives that are setup as follows:
>
>  
>
> On Channel 0 of the PERC controller there are two disks, setup in a RAID 1
> (mirror)
>
>  
>
> On Channel 1 of the PERC controller there are 4 disks, setup in a RAID 5.
>
>  
>
> The SPLAT install says all hardware is compatible and it goes into the
> install. Once it begins formatting the /opt partition, it seems to hang.
> I_ve tried it three different times and it has currently been setting at the
> formatting /opt screen for 24 hours.
>
>  
>
> Ive tried this on two different identical 2850_s with both giving the same
> results.
>
>  
>
> Am I missing something here? Can anyone see something wrong with my hardware
> setup?
>
>  
>
>  
>
>  
>
>  
>
> Classification:  UNCLASSIFIED 
> Caveats: NONE
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV AT amadeus.us.checkpoint DOT com
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner AT ts.checkpoint DOT com
> =================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================