When I installed R55 SPLAT on my 2850s a while back I needed to get a
special image from Check Point. The original image didn't recognize the
RAID controller even though the hardware compatibility check said everything
was OK.
Ron Olsen
-----Original Message-----
From: Dearing, Jimmy (EDS Contractor)
[mailto:jimmy.wayne.dearing AT us.army DOT mil]
Sent: Tuesday, May 23, 2006 9:34 AM
To: FW-1-MAILINGLIST AT amadeus.us.checkpoint DOT com
Subject: [FW-1] Installing SPLAT on Dell PowerEdge 2850 (UNCLASSIFIED)
Classification: UNCLASSIFIED
Caveats: NONE
Ive been attempting to install SPLAT on a Dell PowerEdge 2850 Server that
has dual 3.8ghz processors with 2mb L2 Cache, 12gb RAM, Dual Embedded Intel
Gigabit1 82541 Server Adapter, PERC 4e/Di controller. It has six 15,000rpm
146gb hard drives that are setup as follows:
On Channel 0 of the PERC controller there are two disks, setup in a RAID 1
(mirror)
On Channel 1 of the PERC controller there are 4 disks, setup in a RAID 5.
The SPLAT install says all hardware is compatible and it goes into the
install. Once it begins formatting the /opt partition, it seems to hang.
I_ve tried it three different times and it has currently been setting at the
formatting /opt screen for 24 hours.
Ive tried this on two different identical 2850_s with both giving the same
results.
Am I missing something here? Can anyone see something wrong with my hardware
setup?
Classification: UNCLASSIFIED
Caveats: NONE
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
