When enabling monitor firewall state if cpstop is issued or any other
command that drops the policy (fw unload) and such the vrrp will fail to
the other box.
You can even set the timeout of the failover I suggest you read the
implementation guide of nokia regarding VRRP
-----Original Message-----
From: Mailing list for discussion of Firewall-1
[mailto:FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM] On Behalf Of Zubair
Jalal
Sent: Thursday, May 25, 2006 1:10 PM
To: FW-1-MAILINGLIST AT AMADEUS.US.CHECKPOINT DOT COM
Subject: Re: [FW-1] vrrp and cp
Vrrp is n/w based and not application based. It will fail only if one of
the interfaces goes down on the primary box....
Cpstop will not force a failover
The information contained in this electronic message and any attachments
to this message are intended for the exclusive use of the addressee(s)
and may contain proprietary, confidential or privileged information. If
you are not the intended recipient, you should not disseminate,
distribute or copy this e-mail. Please notify the sender immediately and
destroy all copies of this message and any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient
should check this email and any attachments for the presence of viruses.
The company accepts no liability for any damage caused by any virus
transmitted by this email.
www.wipro.com
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
