Hi Guys,
Is it possible to change the TCP port of the GUI in the Provider-1 MDG or
SmartDashboard and Tracker to use other tcp port instead of the default
tcp 18190 port (CPMI)? Is there something in the registry setting in windows
that the GUI run on that I can do to make it happen?
The reason I want to do it is my Provider-1 sit behind a Cisco router and
I am doing redirect on the router to get to my Provider-1 via MDG. The
MDG works fine but I can not redirect the same port twice on the Cisco router
or Cisco Pix for that matter. With Windows Remote desktop I can redirect
port 3390 to tcp 3389 by typing the command 129.174.1.13:3390.
Is it possible with either MDG or SmartDashboard. Thanks a lot for your help.
cisco4ng
---------------------------------
Yahoo! Messenger with Voice. PC-to-Phone calls for ridiculously low rates.
---------------------------------
Love cheap thrills? Enjoy PC-to-Phone calls to 30+ countries for just 2¢/min
with Yahoo! Messenger with Voice.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
