clish
show vrrp
or on the csh: ifconfig -a ... you should see the real if ip and the vrrp
address.
Best rgds
jochen
>>> Tauseef_Khan AT 3I DOT COM 25.08.2006 16:06 pm >>>
Hi All
How can tell from the cli that which firewall is active. I am running
AI r55 on ipso3.8. I ca run tcpdump on the interface to see the traffic
going through live firewall but is there any other way to tell which
machine Is active and which is standby..
Kind regards
Tauseef
*************************************************
For addressee only. No legally binding commitments will be created by this
e-mail message. Where we intend to create legally binding commitments these
will be made through hard copy correspondence or documents.
3i Investments plc
Registered office:
16 Palace St
London
SW1E 5JD
Registered no:3975789
Authorised and Regulated by the Financial Services Authority
If you are not the intended recipient it may be unlawful for you to read, copy,
distribute, disclose or otherwise use the information in this e-mail. If you
are not the intended recipient please contact us immediately. E-mail may be
susceptible to data corruption, interception and unauthorised amendment, and we
do not accept liability for any such corruption, interception or amendment or
the consequences thereof.
3i is committed to following policies which protect your privacy and comply
with current international data protection laws and regulations in respect of
personal data. Further details of these policies can be found at www.3i.com.
*************************************************
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
