Check the topology info for all interfaces:
Interface Properties > Topology
You should have "IP addresses behind this interface" defined on each one of
them, with the obvious exception of the external one, make sure to create a
group and select it when there is more than one network range behind one of
them.
On 8/31/06, Will Miao <wmiao AT becrypt DOT com> wrote:
Hi,
I am getting a lot of address spoofing alerts from Smart Defence.
Orgin: My firewall
Information: CPMAD
Are these actual attacks or have I mis configured something? I have set
the external interface within the topology of my firewall object.
Thanks,
Will.
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
--
Sergio Alvarez
(506)8301342
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
