Hi,
I need to connect two clustered Checkpoint Firewalls (HA, hot standby)
to a cisco router, but _not_ with a switch between. The firewalls are
to be directly connected to two seperate ports at the Cisco router.
Does anybody happen to know how to configure the Cisco in order to
search for the virtual ip address on two separate ports? (i.e. route
the traffic to the virtual address to both router interfaces)
regards
Hadmut
=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV AT amadeus.us.checkpoint DOT com
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner AT ts.checkpoint DOT com
=================================================
|
